ACCESSORY / MEASURE & MARK
Task light & magnifier
Make the cutting line easier to see without obstructing the work.
By GrainBench · Reviewed October 23, 2026
Jump to a section
When it earns a place in your kit
Make the cutting line easier to see without obstructing the work. Use it only where the design and actual stock call for this operation.
Compatibility & a first test
- Match these first
- Check mounting reach and glare on the paper. Keep the lamp and cable outside the full workpiece sweep.
- Try it on a sample
- Adjust glare and magnification before beginning a test cut.
- Stop and recheck if…
- A lamp positioned over the line can become an obstacle during rotation.
GrainBench setup prompts. The exact operating and installation instructions remain the reference; see the sources below.
A practical setup sequence
Position the light with the saw stopped.
Move the stock through its intended turns.
Adjust glare and magnification before beginning a test cut.
A common mistake to avoid
A lamp positioned over the line can become an obstacle during rotation.
Before you shop
Ask a tool supplier for the exact capacity, accessory fit and operating instructions your project needs. Compare the category guidance here with the manufacturer’s current documentation before buying.
No specific retailer or stock availability has been verified for this category.
Use it with
Sources and scope
References checked October 22, 2026. Named-product instructions illustrate the category and do not establish compatibility with every tool. Use the exact model’s instructions for capacity, settings, guarding and protection. No independent product testing or load rating is claimed.
Browse the equipment library → · Read project planning guides →