CONSUMABLE / SAND & FINISH
Iron-on edge banding
Cover exposed plywood edges with an adhesive-backed strip.
By GrainBench · Reviewed October 22, 2026
Jump to a section
When it earns a place in your kit
For designs that call for covered panel edges. Decorative banding is not a substitute for a designed structural lip or shelf reinforcement.
What to check before choosing
- Check actual panel thickness and choose enough band width for trimming.
- Confirm adhesive type, species or finish compatibility, and the product’s exposure limits.
A practical setup sequence
Prepare a clean, flat edge and test adhesion on scrap using the specified heat and pressure.
Cut the strip with the product’s recommended end allowance. Apply heat and pressure consistently along the edge.
Allow the bond to set as instructed, then trim with a suitable tool and inspect the face veneer for damage.
A common mistake to avoid
Overheating can damage the adhesive or surface; a lifted edge needs its bond corrected rather than hidden under finish.
Use it with
Sources and scope
References checked October 22, 2026. Named-product instructions illustrate the category and do not establish compatibility with every tool. Use the exact model’s instructions for capacity, settings, guarding and protection. No independent product testing or load rating is claimed.
Browse the equipment library → · Read project planning guides →